Originally Posted by tazzmann
Hey dye gods, I have a question. I ordered some of the free sample vinyl from 3M that was suggested on another forum, so I am not using cheap stuff. Anyway, My first dye job went ok, but I had a few problems related to me and not the vinyl.
After that, the next TWO dye jobs I had a problem with the vinyl leaving the glue behind.
I tried different ways of pulling the vinyl off and made sure the heat in the pan for the dye was not too hot. Has any of you had this problem? If so, how did you fix it?
Thanks for the great question. I have had the same problem from time to time, and it was frustrating to say the least. Thanks for the all the expert advice. Going to look into the silicon based stuff.